BPS C-100 Manual de servicio descargar pdf (Pagina 34)

Communicating with the Device Leuze electronic

32 BPS 37 Leuze electronic

9.2 Overview of Commands and Parameters

Online commands can be used to send commands directly to the device for control and

configuration.

For this, the BPS 37 has to be connected to a host or service computer via the serial inter-

face. The commands can be sent either via the host or the service interface.

9.2.1 General ’Online’ Commands

Command Description

M+ Activating the measurement

M- Deactivating the measurement

Reversing the count direction

With the standard setting, the calculation is performed back from the max.

measurement length (10000 metre)

MNx=yzzzzzzz

Set pre-set value

x = T = value is stored temporarily

(the value is erased after switching on and off)

x = D = value is stored permanently in the EPROM

y = sign for pre-set value

zzzzzzz = specification of the pre-set value in mm

Example: MND=+0001000

Current position is set permanently to +1000 mm.

MNR

Deactivates the pre-set value. The unformatted measurement value is

output.

MMxyyyy

Controls the data output via the service interface

x = S = a measurement value is output (Single Shot Mode); subsequent

specification of the time not necessary

x = T = measurement values are output cyclically; time must be subse-

quently specified

y = time specification in ms

Example: MMT0500

Measurement values are output via the service interface in a time interval

of 500ms

MM-

Deactivating the function MMTyyyy

If the cyclical output via the service interface is no longer required, the

function must be deactivated using the command MM.

PC20

Resetting all parameters in the BPS 37 to Leuze default values.

Version query

1 2 ... 29 30 31 32 33 34 35 36 37 38

Sin comentarios

BPS C-100 Manual de servicio Pagina 34