BPS C-100 Manual de servicio descargar pdf (Pagina 29)

Leuze electronic Commissioning

Leuze electronic BPS 37 27

TNT 35/7-24V

7 Commissioning

7.1 Measures to be performed prior to the initial commissioning

device(s)!

made.

7.2 Function Test

"Power On" test

After connecting the operating voltage, the BPS 37 performs an automatic "Power On" func-

tion test. Subsequently, the green LED lights up in the optics window of the BPS 37.

Interface

Proper function of the interface can be tested easiest in service operation using the service

interface with the "BPSConfig" programming software and a notebook computer. For order

numbers, see table 5.1 on page 14.

Online commands

Using the ’Online’ commands, important device functions can be checked, e.g. proper func-

tioning of the laser.

Problems

Should a problem persist after checking all electrical connections and settings on the

devices and host, please contact a Leuze service office near you (see the back page of this

operating manual).

7.3 Setting the Parameters

You have now commissioned the BPS. Usually, you will have to configure it before you can

use it. Using the parameter options made available by the BPS, you can configure the BPS

to suit your individual area of application. For instructions regarding the various setting

options refer to chapter 9 or to the online help of the BPSConfig program.

The setting is usually accomplished by using the program BPSConfig, see "Installing the

"BPSConfig" software" on page 30.

To understand what is happening during the parameter setting, the following chapter 7.3.1

briefly explains the various parameter sets.

The setting of the parameter sets then takes place in the operating mode "service", which is

described in chapter 7.3.2.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 37 38

Sin comentarios

BPS C-100 Manual de servicio Pagina 29